8. Scanning for an active radio channel:
Press and hold the UP ▲ button for 2 seconds: The “SCAN” function
indicator will appear on the display and the channel will scan continuously.
Once an active channel is found, the scanning will stop and you can listen
to the transmission. When the transmission has stopped on that channel,
the scan function will resume automatically.
Note:
If you press the PTT button while listening to a found channel, the device
will go back to stand-by mode on the found channel.
9. Monitor:
Press and hold the DOWN▼ button about 3 seconds to activate monitor.
Release the DOWN▼ button to return to standby mode.
10. Setting the Call tones:
The device has 10 call tones. Press the MENU button 4 times, “CA” is
displayed and on the current call tone. Press the UP▲/Down▼ button to
change to another call tone. Press the PTT button to confirm and return to
stand-by mode.
To Next Page
Loading...