Nexus 21 E-550 - Page 35

Copyright 2020 ©, Nexus 21 Technology in Motion
RF Control FAQ
How do I replace the batteries in my remote?
The RF Remote comes with a life-time battery and cannot be replaced. Try following the steps to resync your RF Remote to the
RF Receiver, if that doesn’t work contact our technical support department for a replacement.
How do I resync my RF Remote?
To resync your RF Remote, you’ll need a paper clip or something similar.
1. Locate your RF Receiver, this should be inside the enclosure for your lift next to the Control Box.
2. Locate the small hole on the side of the RF Receiver (see page 1 for reference).
3. Push the button inside the hole on the RF Receiver while simultaneously pressing the Up button on your RF Remote.
Continue to hold these buttons for 5 seconds before releasing.
4. Test the function of your remote, if you still do not get any movement repeat these steps or contact technical support.
How do I Integrate my lift system using RF?
The RF Controls are meant to be a standalone control for users without a Control System. If you need the ability to integrate,
you will need to use the Control System Integration Kit, Contact Closure, or IP Control Module to integrate your lift.
We offer 3 types of integration, IR, IP, or Contact Closure. As a courtesy we offer a free control swap from RF to IR. For IP or
Contact Closure, contact your account manager or our technical support department for more information.
Technical Support
P
P
h
h
o
o
n
n
e
e
:
:
480-306-5462
E
E
-
-
m
m
a
a
i
i
l
l
:
:
support@nexus21.com
35