Nexus 21 L-50s - Page 18

18
Step 26: Using a pencil, sharpie, or felt-tipped
pen, mark the position for the Tapered Pins
from the underside of the Top Plate.
Step 27: Remove the Lid, and drill two holes ½” deep in the two
marked positions using a 7/32” drill bit.
Step 28: Thread the provided Tapered Pins into the holes using a phillips
screwdriver.
Note: Glue can be used to further secure the pins into position. If using
granite, you can bore the hole slightly larger than the pins and Epoxy it
into place.