!Page!4!
Troubleshooting
The following information should help you diagnose basic setup or installation problems.
COVERAGE LED is OFF: Plug the problem GCA-1200 unit into a power socket next to
the other GCA-1200 unit; both GCA-1200 having been connected by Ethernet cable to
their respective devices (e.g. PC, Router, Set Top Box, etc.). After 10 seconds (approx.),
the COVERAGE LED should light up GREEN. If not, first Factory reset both devices by
pressing the Config button on each for more than 10 seconds. Then, go to part B and
follow the installation steps.
ETHERNET LED is OFF: If the ETHERNET LED fails to light up, check that the LAN port of the
GCA-1200 unit is connected firmly to the LAN port of the other device. To check the
condition of the Ethernet cable, use another cable to test the same connection.
ADDITIONAL HELP:
Visit the GCA-1200-KIT Product Webpage for additional resources such as a User
Manual, FAQs, and/or Videos.
Link: nexuslinkusa.com/product/gca-1200-kit
Support:
Call: (855) 337-6750 Email: Support@NexusLinkUSA.com
To Previous Page
Loading...
