1. Paint the bezel frame and the grille at the same time using the same paint.
2. When using spray paint, apply two thin coats, making sure to let the first coat dry completely before applying the sec-
ond. This will avoid running. When using a compressor and spray gun, apply the paint using its finest setting. Hold the
gun or spray can 24” from the grille when painting, this will help keep the holes from getting clogged. Painting with a brush
is not recommended, but when necessary be sure to thin the paint so as not to cover the holes in the grille. If paint does
cover any of the grille holes, poke them out with a paper clip.
3. Do not attempt to paint the black surface surrounding the driver on the enclosure. Its black finish prevents the sub-
woofer’s black driver from being visible once the grille is attached.
Connecting the iWS to your system
Connect the iWS from the front L & R audio signal
and employ a high-pass filter for the front L & R speakers
Use if:
You wish to send your front L & R speakers a high-pass filtered signal
iWS Connection Method #1
To Next Page
Loading...
