© 2011 National Instruments Corporation. All rights reserved. 375745A-01 June 2011
Regulatory Compliance
Safety Voltages
Measurement Category I is for measurements performed on circuits not directly connected to the electrical distribution system. This
category is for measurements of voltages from specially protected secondary circuits. Such voltage measurements include signal
levels, special equipment, limited-energy parts of equipment, circuits powered by regulated low-voltage sources, and electronics.
Caution Do not use this device for connection to signals or for measurements within Measurement Categories II, III, or IV.
CE Compliance
This product meets the essential requirements of applicable European Directives as follows:
• 2006/95/EC; Low-Voltage Directive (safety)
• 2004/108/EC; Electromagnetic Compatibility Directive (EMC)
Waste Electrical and Electronic Equipment (WEEE)
EU Customers
This symbol indicates that waste products must be disposed of separately from municipal household waste,
according to Directive 2002/96/EC of the European Parliament and the Council on waste electrical and electronic equipment
(WEEE). All products at the end of their life cycle must be sent to a WEEE collection and recycling center. Proper WEEE
disposal reduces environmental impact and the risk to human health due to potentially hazardous substances used in such
equipment. Your cooperation in proper WEEE disposal will contribute to the effective usage of natural resources. For
information about the available collection and recycling scheme in a particular country, go to ni.com/citizenship/weee.
Statutory Warranty Rights
For private individual users in the EU:
Based on your statutory rights, National Instruments will—through its distributor—cure defects in materials and workmanship
within two years from delivery.
To Next Page
Loading...
Need help?
General
