Page 5For technical questions, please call 1-888-866-5797.Item 58145
Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
Inspect Sprayer before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use Sprayer until repaired.
Follow all guidelines regarding chemicals sprayed, including MSDS instructions and EPA regulations.
Release pressure in Tank before loosening or removing parts.
Contents are under pressure and may spurt forcefully.
1. Make sure Handle is pushed all the way down into
Tank. Turn Handle Assembly counterclockwise to
loosen it. Pull the Handle Assembly out of the Tank.
2. Pour the liquid, through a strainer (sold
separately), into the Funnel Top.
Note: Do not use undiluted bleach with this sprayer.
Note: Fill the Tank no higher than max. fill line.
3. Replace Handle Assembly. Make sure Handle
is pushed all the way down into the Tank. Turn
Handle Assembly clockwise to tighten it securely.
4. Pump the Handle 20-30 times to build
sufficient pressure. Once the Sprayer is
pressurized (as indicated by increased tension
on the Handle), discontinue pumping.
5. Hold the Spray Wand Handle with the Nozzle
pointed away from you or any bystanders.
Press and hold the Trigger to begin spraying.
6. Twist the Nozzle to adjust the spray pattern.
7. For continuous spray, press the Trigger down
and forward until it locks, then release the
Trigger. To stop continuous spray, press
down and pull back on the Trigger.
Trigger
(Unlocked)
Trigger
(Locked)
8. As you continue to spray, the Sprayer will
depressurize. Release the Trigger to stop spraying.
Pump the handle 20-30 times to rebuild pressure.
9. When finished spraying:
• Depressurize the Tank.
• Dispose of liquid.
• Clean the Sprayer according to
Maintenance Instructions.
Note: To despressurize without spraying, carefully
turn the Handle Assembly counterclockwise. Lift
Handle Assembly slightly to depressurize contents.
To Next Page
Loading...