Nibe ROT 10 - Connection and Display; Connecting Wireless Units; Display Icons and Repeaters

CONNECTION
Pairing is performed in the heat pump’s/control module’s
display, select menu 5.4 – Wireless units. ROT 10 should
be paired before it is installed on the wall.
Settings for control are made in menu 1.3.3 - Room
sensor settings.
PAIR YOUR WIRELESS ACCESSORY WITH
YOUR MAIN PRODUCT
Wireless accessory
Main product
Menu 5.4 – Connect wireless units
WIRELESS UNITS
Room sensor
ROT10
Add unit
Here, you connect your wireless units. Press "Add unit"
and follow the guide that is launched. You can also check
the connected units’ battery level and signal strength.
REPEATER RPP 10
If the signal strength between the main product and the
accessory in a zone is low, you may need to install a
repeater to amplify the signal between the zones.
1 2
3
1 2
3
Main product Repeater
DISPLAY
°C
°F
°C
°F
1
2
3
4
5
6
7
8
9
10
11
12
13
The display in ROT 10 presents the latest set point value
and measured temperature.
Description
Character display1
Humidity in the zone2
Week day3
Scheduling activated in the main product4
Battery status5
Holiday mode activated in main product6
Key lock activated.7
Home/away mode activated8
signal strength9
"More hot water" activated10
Cooling activated in the zone
1
11
Heating activated in the zone
1
12
Room temperature13
1
Flashes when the compressor is in operation
ROT 10 | GB14