Program settings
MENU SETTINGS
Caution
RPP 10 is not connected to a zone, and there-
fore you cannot make the same settings as
with other wireless units.
MENU 5.4 – WIRELESS DEVICES
In this menu you connect wireless units, and manage
settings for connected units.
Add the wireless unit by pressing "add unit". For the
quickest identification of wireless unit, it is recommen-
ded that you put your master unit in search mode first.
Then put the wireless unit in identification mode.
A zone is created automatically when you connect a
new wireless room sensor. (Default setting: One zone
per climate system.)
When you decide to create additional zones, you select
a name as well as the climate system to which the zone
will belong.
MENU 5.4.5 – REPEATER RPP 10
Name unit
Enter a name for the relevant repeater.
Identify
Setting range: on/off
Delete unit
Setting range: yes/no
Name unit: Here, you name your repeater RPP 10.
Identify: When the function is activated, the LED indic-
ator on RPP 10 flashes green so it can be identified.
Delete unit: Here, you can choose to remove the unit.
MENU 6.2 – SCHEDULING
In this menu, you schedule the power outlet in RPP 10
to control the times at which the current will be turned
on and off.
Caution
A schedule repeats according to the selected
setting (e.g. every Monday) until you go into
the menu and switch it off.
13RPP 10 | GB
To Next Page
Loading...
