Nice BIO Series

- 26-
!
LEARNING
Each transmitter has its own code (selected from over 1 million codes) that identifies it from any other remo-
te control. The receiver is designed to receive all codes, but will only be activated if its own individual code is
stored in the list of ‘authorized’codes. A code is entered into the list via a procedure called ‘learning’in which
the receiver directly recognizes the code. This procedure (or other similar ones) must be enabled by the ope-
rator by pressing a button located on the receiver card.
The various stages of the procedure are displayed by small LED indicator.
This LED will provide different indications depending on the meaning.
LED off: Normal operation
LED on: Time valid for learning procedure (approx. 5 sec.)
1 flash : Received code is not authorized
2 flashes* :Timeout out on learning without result
3 flashes : Learning completed with positive result
4 flashes : Code already in authorized code list
5 flashes : Code list is empty
6 flashes : Code list is full up (no room left for new codes)
7 flashes : Cancellation requested for code not in list
8 flashes : Different codes were received in learning stage
9 flashes : Password entered.
* If the second type of lock is enabled, the 2nd flash will be longer the first.
If the second type of lock is disabled, both flashes will be equally long.