10 – English
EN
...
1
.sec.
...
“B”
Hold down Wait LED Release Actuate the blades Up Series of flashes
Stop the blades Series of flashes Press 1 time ( Down)
“LED” (red-green)
“LED” (red)
flashing
flashing
To escape the procedure at any point
NOTE
Step 5 - Testing the “Wind” sensor
2
.sec.
2
.sec.
“B”
3
.sec.
Series of flashes Release Wait Series of flashes
Hold down Wait LED Release Finger on sensor Wait Up
“LED” (green-red)
flashing
(orange)
(red)
“LED” (orange)
flashing
Warning! The rain sensor may be hot (about 45°C).
To escape the procedure at any point
NOTE
Step 6 - Testing the “Rain” sensor