Nice E FIT M 817 BD - Page 24

option – C
5 6
end
5
sec.
3
= 5 sec
5
Hold down the but-
ton and
count 3 movements; release the button. On the transmitter to be deleted: hold down
any key either the key memorised in mode 2 or
the climatic conditions sensor;
count 5 movements.
option – D
5
end
5
sec.
5
Hold down the but-
ton and
count 5 movements; release the button.
• Note – When performing the procedure, you can cancel the programming at any time by holding down n and t together for 4 seconds. Alternatively, do not press
any keys and wait 60 seconds for the motor to perform 6 movements.
D.4.2 - Procedure run with a transmitter which has not yet been memorised
• Before starting the procedure, bring the awning to halfway along its path.
1 2 3 5
...
OFF
ON
Run procedure D.4.1. in
full.
Disconnect the electrical pow-
er supply to the motor.
Connect the brown and blue leads to each other. Reconnect the electrical power sup-
ply to the motor once again.
D.5 - Locking and unlocking the motor’s memory
MONO
NOTES AND WARNINGS
• Locking the motor’s memory stops any other (unscheduled or unauthorised) transmitters being memorised in it.
1 2
 3
5
sec.
2
5
sec.
3
Hold down the but-
ton and
count 2 movements; release the
button.
Hold down the but-
ton and
count 3 movements; release the
button.
3 4
 5
5
...
5
sec.
3
5
sec.
2
Select one of the following potions and ex-
ecute it:
• option A – LOCK motor’s memory.
• option B – UNLOCK motor’s memory.
Hold down the but-
ton and
count 3 movements; release the
button.
Hold down both
buttons;
count 2 movements; release the
buttons.
option – A
5
end
option – B
5
end
5
sec.
3
= 5 sec
5
Hold down the but-
ton and
count 3 move-
ments;
release the button. Hold down the but-
ton and
release it after 5
seconds;
count 5 movements.
D
23 – English