Nice E MAT ST 524

Nice
EN - Instructions and warnings for installation and use
SV - Anvisningar och säkerhetsföreskrifter för installation och användning
E MAT ST 324
E MAT ST 524
E MAT ST 611
E MAT ST 1011
E MAT MT 817
E MAT MT 1517
E MAT MT 3017
E MAT MT 4012
Tubular motor

Nice E MAT ST 524 Specifications

General

Brand	Nice
Model	E MAT ST 524
Category	Engine
Language	English

Summary

Quick start guide

3 - Adjust limit switches 0 and 1 in SEMIAUTOMATIC mode

Setting upper and lower limit positions using semiautomatic mode.

1 WARNINGS AND GENERAL PRECAUTIONS FOR SAFETY

1.1 - Installation warnings

Safety instructions and precautions for installing the motor.

1.2 - Use warnings

Safety instructions and precautions for using the motor.

3 INSTALLATION OF THE MOTOR AND THE ACCESSORIES

3.1 - Preliminary checks before installation and limitations on use

Checks to perform before installing the motor and usage restrictions.

3.2 - Assembly and installation of the tubular motor

Steps for assembling and installing the tubular motor.

4 ELECTRICAL CONNECTIONS AND FIRST POWER UP

4.1 - Connection of motor to electricity mains

5 PROGRAMMING AND ADJUSTMENTS

5.5 - Memorising the FIRST transmitter

5.6 - Manual adjustment of upper limit switch height (0) and lower height (1)

5.6.1 - To adjust the UPPER limit switch (0)

Step-by-step guide to manually set the upper limit switch.

5.6.2 - To adjust the LOWER limit switch (1)

Step-by-step guide to manually set the lower limit switch.

5.7 - Semiautomatic programming of the limit switches

5.8 - Automatic programming of both limit switches

5.9 - Adjusting height (H) for partial openingclosing

5.10 - Memorising a SECOND (third, fourth, etc.) transmitter

5.10.1 - Memorising a second transmitter Mode I

5.10.2 - Memorising a second transmitter in Mode II

5.12 - RDC Function: adjustment of the motor traction force when closing

5.16 - Total or partial deletion of memory

5.16.1 - Procedure performed with a transmitter memorised in Mode I

5.16.2 - Procedure performed with an unmemorised transmitter

5.17 - Locking and unlocking the memory

7 WARNINGS FOR ORDINARY USE OF THE MECHANISM

7.1 - Maximum continuous work cycle

7.2 - Automatic limit switch update function

7.3 - Commanding partial openingclosing of the awning (height H)