Nice E FIT M 817 BD - Page 27

1 2 3
 4
“H
”
5
sec.
2
5
sec.
4
Move the awning to the
desired “H” position.
Hold down the but-
ton and
count 2 movements; release the button. Hold down the but-
ton and
count 4 movements; release the button.
4 5
 5
5
sec.
2
Precisely ad-
justing the
“H” posi-
tion 
“H
”
Hold down both
buttons...
count 2 movements; release the
buttons.
Press the buttons until you reach the desired position.
5 6
...
5
sec.
3
Select one of the following potions and
execute it:
• option A – to memorise the FIRST
“H” position.
• option B – to memorise a SUPPLE-
MENTARY “H” position.
Hold down the but-
ton and
count 3 movements; release the button.
option – A
6
end
option – B
6
end
8
sec.
4
4
Hold down both but-
tons...
count 4 movements; release the but-
tons.
On ANOTHER transmitter, which
has NOT been memorised: hold
down any button you wish;
count 4 movements.
D.9 - “RDC” Function: adjustment of the motor traction force when closing
MONO
NOTES AND WARNINGS
• This function prevents the excessive traction of the canvas at the end of the closing manoeuvre. During the final phase of this manoeuvre, the function automatically
reduces the motor traction torque, based on the factory setting or the one adjusted by the installer with the following procedure.
• Warning! – This function is active with the factory setting but is not applicable if the limit switches are programmed with the manual procedure (D.6).
1 2
continues

5
sec.
2
Select the desired
option and program
it as follows 
0,5
sec.
5 OPTIONS:
x 1 = standard sensitivity (*)
x 2 = minimum sensitivity
x 3 = medium sensitivity
x 4 = maximum sensitivity
x 5 = function deactivated
Hold down both
buttons...
count 2 movements; release the but-
tons.
Press and release the button the number of times indicated in the option you
have chosen;
 2
3
end
Note – When performing the procedure, at
any time you can cancel it by keeping the n
and t keys pressed simultaneously for 4 sec-
onds. Otherwise, do not press any key and
wait 60 seconds for the motor to perform 6
movements.
10
sec.
?
1 /
2 /
3 /
4 /
5 /
5
sec.
3
after about 10 seconds, the motor performs a num-
ber of movements equal to the number of pulses
entered.
Hold down the but-
ton and
count 3 movements; release the but-
ton.
(*) = Factory setting.
D
English – 26