19 – English
EN
G
To activate or deactivate the special “Sensor ON/OFF” function within one or more groups
Caution! • If there are no climate sensors in your installation, please ignore this procedure. • Before carrying out the procedure we advise you to read the descrip-
tion of the special “Sensor ON/OFF” function in Section 1 of the manual. • The user may only set the function manually when the automatic mode is deactivated (i.e. when
you see “Man” on the display).
01. Call up the term “Man” on the display (= automatic mode deactivated).
02. Press “sel” repeatedly sending the
(flashing) cursor through the various groups (note – after group 6, if you wish to return to group 1, press “sel” another 3 times); then
stop the cursor next to the group you wish to select. • Confirm the selection with “ok”: (the cursor
will stop flashing).
03. If you wish to form a “multiple group”, repeat step 02 for each group you wish to add to the “multiple group”.
04. After selecting the group, press “sel” repeatedly until the required option is displayed for the special “Sensor ON/OFF” function:
- “Sun ON” = to activate the management of the automation system via automatic commands coming from the climate sensors;
- “Sun OFF” = to deactivate the management of the automation system via automatic commands coming from the climate sensors;
- “sun ON and sun OFF” = to completely ignore the existence of climate sensors.
If you go past the required option by mistake, continue pressing “sel” until the option you want appears again. At the end, the chosen icon flashes. • Confirm the option
by first pressing “ok” and then the key n. The chosen icon stops flashing.
Step 1 Step 2 Step 3 ...
example:
If you wish to form a “multiple
group”, repeat step 03 for each
group you wish to add to the
“multiple group”.
To Next Page
Loading...
