example:
(permanently ON)
conrm 1 time (display)
Important – From this moment on, the chosen setting for this special function will
remain the same until the automation systems in question receive a different setting
due to an event occurring or if the user goes through this procedure again.
10 - BATTERY REPLACEMENT
When “ ” displays, it is time to change the batteries as soon as possible. In this
situation, there is a risk that the commands may not be sent properly to the automa-
tions. Replace the batteries as shown in the figure below.
Caution! – Once you have replaced the batteries, you must make the basic
settings again with Procedure 1.
• Disposing of batteries
Caution! – Discharged batteries contain pollutant substances and therefore must
never be disposed of as normal waste. Dispose of observing waste separation and
collection procedures as required by local regulations.
To Next Page
Loading...
