Nice ERA TIME - Page 5

English – 4
EN
PROCEDURE 2 - Memorizing the ERA TIME as “First Transmitter”
Run the following procedure only if no transmitters have yet been memorized; otherwise use Procedure 3.
Step 1 Step 2 Step 3 Step 4 ...
on
stop/esc
main
screen
Auto
sel
Auto
Man
Prog
ok
Man
(perma-
nently ON)
sel
example:
1 2 3
4 5 6
power up the motor several times... (display) 1 time (display) conrm (display) select the GROUP
(1)
... Step 4 Step 5 - end
NOTE:
(1) - This step requires you to select the group (i.e.
transmission channel) to which the automated
system is to be assigned.
ok
example:
1 2 3
4 5 6
stop/esc
3
stop/esc
conrm (permanently ON) hold down ... 3 movements ... release
PROCEDURE 3 - Memorizing the ERA TIME as “Second (third, fourth...) Transmitter”
Run the following procedure only if one or more transmitters are already memorized in the automation. If no transmitter has yet been memorized, you MUST
use Procedure 2.

Step 1 - 2 - 3 - 4 Step 5

Step 6
On a new
ERA TIME, not yet
memorized
Execute step
1 - 2 - 3 - 4
of Procedure 2
stop/esc
10
sec.
stop/esc
On an old
transmitter, already
memorized
stop/esc
hold down ... wait ... release 3 times

Step 7 - end
NOTE:
(1) - If the motor moves 6 times, the memory is full (max. 30 transmit-
ters) and the new transmitter could not be memorized.
On a new
ERA TIME, not yet
memorized
stop/esc
3
stop/esc
hold down ... 3 movements
(1)
... release