25
GB
250
1234
1234
450
Each combination is associated with a counter that subtracts 1 from an initial value
every time the combination is used; when the counter reaches zero the combination is
deactivated. The maximum value of the counter is 999, higher values mean unlimited
operations. At the outset, all the combinations have unlimited operations.
1. Enter the programming password
2. Press to confirm the password
3. Enter to select the operation
4. Press to confirm
5. Enter the combination for which the operations counter is required to be reloaded
6. Press to confirm
7. Enter the combination to be reloaded a second time
8. Press to confirm
9. Enter the value to which the counter is required to be loaded
10. Press to confirm
N.B.: If the operation was successful 3 tones will be heard
Table “C15” Load the operations counter of a combination Example
Table “C16” Programme output (Relay 1) in the TIMER mode Example
This procedure associates the TIMER function with output N° 1, so that after
it is activated, the output remains so for the pre-set time (minimum 0.5, maximum
6500 seconds). Set the time to 0 seconds to return to the MOMENTARY mode
1. Enter the programming password
2. Press to confirm the password
3. Enter to select the operation
4. Press to confirm
5. Enter the value of the timer expressed in tenths of seconds ( maximum value: 65,000)
6. Press to confirm
N.B.: If the operation was successful 3 tones will be heard
To Next Page
Loading...
Need help?
General
