Nice MORX User Manual

39
GB
x6
  
x6
 
Table “F14” Programming an output in the TIMER mode Example
This procedure associates the TIMER function with an output and keeps it activated,
for the time pre-set (minimum 0.5, maximum 6500 seconds), after it has been enabled.
Set the TIMER to less than 0.5 seconds to return to the “momentary” mode.
1. Pass the MASTER in front of the reader six times (see note)
2. Then hold the MASTER in front of the READER
3. Wait for 3 tones (the timer starts at the third tone)
4. Remove the MASTER after the required time has elapsed (maximum 1h 50’)
N.B.: At point 1 MASTER 1, MASTER 2 or the SOLE MASTER must be used depending on which output the TIMER mode is to be
associated with (the SOLE MASTER associates the mode with both outputs.) The output is activated while the time is being measured (4).
Table “F13” Programming an output in the ANTI-THEFT mode Example
This procedure associates the ANTI-THEFT function with the two outputs, that is,
the BISTABLE mode on output N°1 (to activate or deactivate an anti-theft system)
while output N°2 gives an impulse when the system is activated and two impulses when
it is deactivated.
Set the “timer” function to less than 0.5 seconds to return to the “momentary” mode
1. Pass the MASTER in front of the reader six times (see note)
2. Then hold the MASTER in front of the READER
3. Wait for 2 tones
4. Immediately after the second tone, remove the MASTER
N.B.: The ANTI-THEFT mode affects both outputs and therefore any MASTER can be used.
M
A
S
T
E
R
M
A
S
T
E
R
M
A
S
T
E
R
M
A
S
T
E
R
M
A
S
T
E
R
M
A
S
T
E
R
C
A
R
D

Nice MORX Specifications

General

Brand	Nice
Model	MORX
Category	Control Systems
Language	English