Nice MORX User Manual

40
(5s)
x3
Table “F16” Delete memory from the DECODER Example
This function deletes all the data contained in the memory, thereby making it possible
to choose between the EASY and PROFESSIONAL modes again.
1. Press and hold down the small button on the DECODER, the LED lights up for 3 seconds
and then flashes 3 times.
2. Release the button exactly during the third flash.
N.B.: if the operation was performed correctly, the LED will flash 5 times after a few moments.
Table “F15” Self-insertion of new CARDS Example
These operations allow other CARDS to be directly inserted by the READER. An active
CARD must be available; the new CARD will also take the STATIC or DYNAMIC
options from this.
1. Hold the new CARD up to the READER for at least 5 seconds
2. After 5 seconds remove the new CARD
3. Pass an active CARD in front of the READER 3 times
4. Pass the new CARD to insert in front of the READER one more time
N.B.: If other CARDS are to be inserted, repeat all the points for each new CARD to insert.
For all the previous PROFESSIONAL mode programming functions it
was necessary to use the MASTER CARD; the following functions,
instead, can be performed without using these special CARDS.
C
A
R
D
C
A
R
D
C
A
R
D
C
A
R
D
C
A
R
D

Nice MORX Specifications

General

Brand	Nice
Model	MORX
Category	Control Systems
Language	English