EN
English – 27
The gearmotor is totally assembled and wired, ready for the
connection.
To avoid any damages it is to be transported, and if necessary
stored, inside the packaging provided for this purpose or another
that is similar with equal characteristics.
For disposal, it is necessary to separate
− metals
− plastic elements
− electrical components
− lubricants.
TRANSPORT / STORAGE / DISPOSAL
TECHNICAL ASSISTANCE / SPARE PARTS /
ACCESSORIES
We specically clarify that we neither carry out tests nor are we willing
to approve any spare parts and/or accessories not supplied by us.
The assembly and/or the use of products of this type could therefore
compromise any predened characteristics at the construction
design level, or reect on safety.
NICE declines all liability and disclaims any warranty whatsoever
for damages, if any, caused by non-original spare parts and/or
accessories.
Defects that cannot be remedied internally are to be eliminated only
by the Door manufacturer or another specialised Company, from
which it is possible to also request any necessary spare parts.
The possible combinations of gearmotors with control stations are indicated hereunder. The gearmotors can work only with the allowed
control stations.
The entire instruction manual is made up of instructions for use regarding the gearmotor and its control station. To this regard
it is necessary to follow the instructions of the control station.
All gearmotors for rolling shutters can operate also with a static frequency converter. To this regard, observe the advice of the
Manufacturer.
COMBINATION OF GEARMOTORS FOR ROLLING SHUTTERS AND CONTROL STATIONS
Combination
Control stations/
Gearmotors for rolling
shutters
140-180Nm 220-450Nm 550-1400 Nm Motors 24RPM
UST2
X X
UST1
X X X
UST1K-2,2 / 5,5kW
X X X X
UST1K-1,1kW
X
To Next Page
Loading...
Need help?
General