NEW FEATURES
• Simplified memory layout allows for quicker and easier programming.
• Phone line now uses RJ12 with standard connections.
NOW AVAILABLE
DRI24 - interface to allow the DT1 to be used with 24V D.C. power supplies,
convenient for use with Fire Panels.
Note that the CH2, CH3, CH4 & CH5 inputs and the 2 relay outputs have no
function when the DRI24 is used with a DT1.
SPECIAL NOTE TO NEW ZEALAND CUSTOMERS
1. Alarm equipment or sensors etc. connected to the inputs shall meet the
requirements of the New Zealand Electricity Act 1993 and its associated codes
of practice.
2. The dialler shall only be powered by an approved power source.
3. The preferred method of dialling is to use DTMF tones as this is faster and more
reliable than pulse (decadic) dialling. If for some reason you must use decadic
dialling, the numbers must be entered using the following translation table as
this dialler does not implement the New Zealand “Reverse Dialling” standard.
Number to be dialled: 0 1 2 3 4 5 6 7 8 9
Number to program in dialler: 0 9 8 7 6 5 4 3 2 1
Note that where DTMF dialling is used, the numbers should be entered
normally.
To Next Page
Loading...