What to do if Nikkai DVR remote control not working?
If your Nikkai DVR remote isn't responding, there are a few potential reasons. First, ensure the receiver is switched on by plugging it in and turning it on. Next, make sure you're aiming the remote directly at the front panel of the DVR and that there are no obstructions blocking the signal. Finally, the batteries in the remote might be exhausted, so try replacing them.
Why does my Nikkai DVR say no signal?
If your Nikkai DVR displays a 'No Signal' message, it could be due to a few reasons. Check that the aerial lead is properly connected. The aerial itself might be damaged or misaligned, so inspect it carefully. Also, confirm that your location is within a digital signal area by checking your postcode.
General| Tuning range | FM: 88-108 MHz, MW: 530-1600 kHz |
|---|---|
| Frequency response | 20Hz to 20kHz |
| Total harmonic distortion | 0.5% |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Signal to noise ratio | 70dB (MM), 80dB (line) |
| Output | 150mV (line) |
| Speaker load impedance | 8Ω to 16Ω |
To Next Page
