Nikko RDC-140003 - Installing Transmitter Antenna; Installing Vehicle Batteries

44
44
4
EnglishEnglish
EnglishEnglish
English
When installing a Ni-Cd battery pack, make sure that
the power switch of the vehicle is OFF.
VehicleVehicle
VehicleVehicle
Vehicle
(1) Join the connectors of the vehicle and
the Ni-Cd pack.
(2) Press down the battery stopper.
Battery compartment
HOW TO INSTALL THE BATTERIES
To remove the battery lid, press the
point marked “OPEN” and pull the lid
downward.
One 9 volt (006P) battery
Install battery making sure that (+) and (-) poles
are positioned properly.
* Dispose the used batteries separately from
other trash.
TransmitterTransmitter
TransmitterTransmitter
Transmitter
3
2. HOW TO INSTALL TRANSMITTER ANTENNA2. HOW TO INSTALL TRANSMITTER ANTENNA
2. HOW TO INSTALL TRANSMITTER ANTENNA2. HOW TO INSTALL TRANSMITTER ANTENNA
2. HOW TO INSTALL TRANSMITTER ANTENNA
Place the transmitter antenna into the
antenna holder to screw it in clock-
wise.
Don’t install the antenna extended. It’s
dangerous.
If the antenna is not screwed in se-
curely, the vehicle may move errati-
cally. Screw the antenna securely.
English