To Next PageTo Next Page
Need help?Do you have a question about the Niko 350-41600 and is the answer not in the manual?
General| Product type | Motion detector |
|---|---|
| IP protection degree | IP20 |
| Material | Plastic |
| Colour | White |
| Operating voltage | 230V AC |
| Detection angle | 360 degrees |
| Light sensitivity | 5 - 1000 lux |
| Operating temperature | -20°C to +40°C |
Detector can be used as presence or absence detector, featuring a built-in light sensor.
Guidance on selecting the optimal placement for the motion detector.
Instructions for correctly wiring the detector unit.
Configure detector as presence or absence mode using specific button presses.
Set ambient light threshold from 100 to 1,000 lux using button presses.
Set the delay for light switch-off after no movement is detected (5-60 min).
Adjust detection sensitivity to four fixed levels (1=highest, 4=lowest).
Activate to test movement detection; green LED lights up on detected movement.
Reset the detector to its original factory default settings.
Read current settings (switch-off delay, lux, sensitivity) via LED flashes.
Use IR remote or app to program settings. Detector locks after 5 mins inactivity.
Keep lens clean for proper function. Clean with damp cloth and mild detergent.
Installation by registered installer, follow regulations, present manual to user.
Contact details for wholesaler or Niko support service for doubts or exchanges.
Four-year guarantee period, consumer obligations, and liability limitations.
