- 37 -
Remarks
• When connecting the terminator to the scanner, insert it
straight, and correctly aligned with the locator key, taking
care not to bend the pins.
• When removing the terminator from the scanner, pull it
straight out, taking care not to bend the pins.
If there is not enough space to connect the terminator directory
to the LS-20, the SCSI connector on the LS-20 should be
attached to the connector stamped in the center of a daisy-
chaining flat cable (not provided), and the provided SCSI
terminator should be attached to the unconnected stamped
connector at one end of this cable.
5.5 SCSI Cables Used with Internal
Scanners
The internal SCSI cable is a 50-pin flat cable with two identical
molded connectors on each end. One end of this cable will
connect to the SCSI controller while the other end will connect
to the connector on the rear of the internal-mount scanner. A
typical SCSI internal cable is shown below.
SCSI flat cable
Connector protection key
SCSI 50-pin connectors
To Next Page
Loading...
