363
n
When an SC-series 17, 28, or 29 sync cable is used for off-camera flash
photography, correct exposure may not be achieved in i-TTL mode. We
recommend that you choose spot metering to select standard i-TTL flash
control. Take a test shot and view the results in the monitor.
In i-TTL, use the flash panel or bounce adapter provided with the flash
unit. Do not use other panels such as diffusion panels, as this may
produce incorrect exposure.
D Use Only Nikon Flash Accessories
Use only Nikon Speedlights. Negative voltages or voltages over 250 V
applied to the accessory shoe could not only prevent normal operation,
but damage the sync circuitry of the camera or flash. Before using a Nikon
Speedlight not listed in this section, contact a Nikon-authorized service
representative for more information.
To Next Page
Loading...
