CT6K01(11)
6MQA4611-01
En
Procedure for Pairing for the First Time (for iOS Users)
Here, pairing refers to the setting used to connect the camera and smartphone or tablet (below, “smart device”)
through Bluetooth.
Parts of the Camera
Movie button
Photo button
Status lamps
Power-on lamp Airplane mode switch
Before Pairing
Camera
• Press and hold the movie button on the camera for about 3 seconds to turn it o. When the camera turns o,
the power-on lamp turns o.
• Use a suciently charged battery so that the camera does not turn o during the procedure.
• Turn o the airplane mode switch on the camera.
• Insert a microSD memory card with sucient free space into the camera.
- Use microSDXC memory cards with a UHS Speed Class rating of 3 or faster when recording movies at an image
size/frame rate of 2160/24p (4K UHD) or 1920/24p.
• Disconnect the HDMI cable or USB cable.
Smart device
• Two types of apps are available: “SnapBridge” and “SnapBridge 360/170”. Use “SnapBridge
360/170” when pairing with the KeyMission 360.
• Do not pair from the Bluetooth setting screen of the smart device.
Pairing Procedure
1 Make sure that the camera is o (the power-on lamp is o ).
2 Enable Bluetooth and Wi-Fi on the smart device.
• Do not pair from the Bluetooth setting screen of the smart device.
3 Install and start the SnapBridge 360/170 app.
4 Press the movie button or photo button on the camera to put it into pairing standby mode.
• When the status lamps ash green at the same time for a while and then alternately ash green, the camera
enters pairing standby mode.
• If the camera remains in pairing standby mode for about 4 minutes, it turns o (the power-on lamp turns o )
automatically. If the camera turns o during the pairing procedure, press the movie button or photo button
on the camera to put it into pairing standby mode.
* If the camera does not enter pairing standby mode even after pressing the movie button or photo button,
press and hold the movie button for about 7 seconds while the camera is o.
To Next Page
Need help?
General
