Nikon SMZ18 - Page 55

Chapter 3 Assembling
41
WARNING Before connecting the power cord
To prevent electric shock, be sure to turn off the power switch (press it to the “” position) at the front of the control box
before connecting the power cord to the adapter.
12
Connect remote control devices. (P2-CTLA Control Box only)
A
ttach the following remote control devices to the P2-CTLA Control Box.
(1) Connect the P2-RC Remote Controller.
Connect the P2-RC Remote Controller to the
connector “REMOTE” of the P2-CTLA Control Box.
1
1
2
3 4
DISPLAY
DISPLAY
BRIGHTNESS
BRIGHTNESS
ESCAPE
ESCAPE
ALZ
AL
Z
−+
LIMIT
LIMIT
ZOOM
ZOOM
STEP
STEP
Z-RESET
Z-RESET
Z-SPEED
Z-SPEED
ZOOM STEP
ZOOM STEP
Coarse
Coarse
FL Cube
FL Cube
ON/OFF
ON/OFF
ON/OFF
ON/
OFF
ON/OFF
O
N
/OFF
ON/OFF
ON/OFF
Fine
Fine
Ex Fine
Ex Fine
1x
1x
0.5x
0.5x
0.1x
0.1x
+
−
Connecting the control box
(2) Connect the AZ-FSW Foot Switch (optional).
Connect the AZ-FSW Foot Switch to the connector
“FOOT” of the P2-CTLA Control Box.
PHOTO CTRL
Connecting the foot switch
(3) Connect the AZ-PCR Photo Release (optional).
Connect the AZ-PCR Photo Release to the
connector “PHOTO” of the AZ-FSW Foot Switch.
PHOTO CTRL
Connecting the photo release