Nikon WU-1a User Manual

Connection Status
The status of the connection between the camera
and the wireless mobile adapter is shown by the
adapter LED:
LED
0 On (green)
Connected
c:Q:c Flashes green once every 2 s I Ready to connect
'""" Flashes green rapidly (rate var- !Transmitting
c"Q,c ies with connection speed)
c:Q:c Slow green flash once every 5 s I Adapter in sleep mode
c:Q:c Flashes red once every 0.5 s
Connection error
Sleep Mode
To reactivate the adapter after it has entered sleep
mode, press the WPS button.
Restoring Default Settings
To restore default settings, keep the WPS button
pressed for over 10 seconds and then press the but-
ton again when the LED flashes orange. The LED will
stop flashing, showing that the adapter has been
reset.
B The Supplied Strap and Case
Use these accessories as shown in Figure 2 to prevent
the adapter being lost or dropped.
B Deactivating the Adapter
To end wireless transmission, turn the camera off and
disconnect the adapter.
IEEE 802.11 b, IEEE 802.11 g
•
IEEE 802.11 b: DSSS/CCK
·IEEE802.11g: OFDM
2412-2462 MHz (channels 1-11)
Approximately 10-15 m/33-49 ft
54 Mbps
• Authentication: Open system,
WPA2-PSK
• Encryption: AES
Supports WPS
Infrastructure
pproximately 1.65 W maximum
·Temperature: 0-40 oC/32-1 04 oF
• Humidity: Less than 85% (no
condensation)
• WU-1a: 18 X 21 X 10 mm/
0.7 X 0.8 X 0.4 in.
• WU-1 b: 18 x 23 x 1 0 m m/
0.7 X 0.9 X 0.4 in.
Approximately 3 g/0.1 oz (body only)
*Maximum logical data rates according to IEEE standard.
Actual rates may differ.
B Trademark Information
GOOGLE PLAY is a trademark of Google Inc. All other
trade names mentioned
in this manual are the trade-
marks or registered trademarks of their respective
holders.

Nikon WU-1a Specifications

General

Output interface	-
Internal	No
Product color	Black
Plug and Play	Yes