Installation
Before you begin, make sure that the sensor/keypad cables, the flash-
er cables and the 12vDC power supply cable will all reach the pro-
posed location of the IRP2+. Mark the cables with labels describing
where the cable originates (rather than which terminal on the IRP2+
it should connect).
For proper installation, follow the steps outlined below in the correct
order. If you discover a fault in the course of installation, go on to the
Troubleshooting Guide before continuing with the next installation step.
8
II
NN FF RR AA RR EE DD
EE
XX TT EE NN DD EE RR
-- MM
AA II NN
SS
YY SS TT EE MM
UU
NN II TT
TOOLS
REQUIRED
• 1/8" Standard
Slotted
Screwdriver
• Wire Stripper
MS-1 Sensor
To
unswitched
AC outlet
Figure 6:
IRP2+ Installation
IRP2+ Sensor
Connection
IRP2+
Receiver
To Next Page
Loading...