Nilfisk-Advance MC 9P - Page 4

Safety instructions
SM_MC 9P_MC 10P Ver.1.0_February_2023
4
A
For your own safety
ESD measures
(electrostatic discharge)
MC9-series, MC10-series
Ultra HPW - Mobile - El - CW 400V 3~
50Hz, 440V 3~ 60Hz, IPX5.
2006/42/EC:
EN 1829-1:2021
EN 1829-2:2008
2014/30/EU:
EN 61000-3-11:2019
EN 61000-3-12:2011
EN 61000-6-2:2019
EN 61000-6-4:2019
2011/65/EU: EN 63000:2018
2000/14/EC - Conformity assessment
procedure according to Annex V:
- Measured sound power level: 95-100
dB(A); Guaranteed sound power level:
98- 104 dB(A)
Repair work should be carried out
by persons instructed in electrical
installations or by trained
electricians only.
Take the following ESD precautions before carrying out any
repairs to the electronics:
• Touch the earth conductor before repairing the cleaner
( to discharge electrostatic charge from your body ).
• Wear wrist band if necessary.
• Use a conductive oor covering or a conductive table cover.
• Never touch the printed circuit board or electronic components
( always hold on to plastic ).
• Transport electronic components in conductive packaging
( e.g. ESD bag ).
Additionally:
Also see national regulations before using the cleaner, always read the operating
instructions and keep them readily available. Only allow the high pressure
cleaner to be used by persons who have been trained in its use and who have
been explicitly authorized to use it.