Safety instructions
SM_MC 9P_MC 10P Ver.1.0_February_2023
9
A
.
WARNING
To prevent accidents from happening, ensure the safety of the person(s) using the equipment and to protect bystand-
ers and nearby placed inventory or machinery, the following safety requirements must be met:
It is not permitted to clean hazardous material (e.g. asbestos) with high pressure, without using proper PPE and equip-
ment.
Persons under the inuence of alcohol, drugs or medicine must not operate the machine.
Do not touch the electrical plug and socket with wet hands.
Always unplug power supply when cleaning and maintaining the machine.
Do not use the machine if important parts are damaged – i.e. safety devices, high pressure hoses, spray handle.
The user is obliged to observe all national working environment and working safety regulations concerning “operation
of high-pressure washers”.
Do not spray directly onto electrical equipment or on the machine itself with high pressure water. Electrical shock may
occur.
Do not operate the machine with damaged or removed fan cover. Motor will overheat and malfunction. If the VHPW
has areas that can get hotter than the limit set by the authorities, these areas will be marked with the following
symbol:
Avoid touching these areas with bare hands before the VHPW has cooled down.
The machine is equipped with the following safety devices:
Emergency stop Button: (Do not use during normal working conditions).
This machine is equipped with an emergency stop on the control panel. When engaged, it will
override all other functions and machine operating modes. The objective is to stop the VHPW as
quickly as possible without creating additional hazards.
To use the emergency stop function, user need to tap hard on the button. When activated, the high pressure machine
will immediately come to a total stop.
To reset the machine, turn the button clockwise to release.
The VHPW will remain in its neutral state.
On MC 9P and MC10P 500 residual pressure can be built up in the hose/
gun. Make sure to release any residual pressure from hose/gun.
To start up the VHPW again, user needs to press the start button again.
To Next Page