Page: 1
SW8000 How To
Prepare for Sweeping
1
Before operating any
machine, read the owner’s
manual carefully and take
time to learn the control
panel functions.
2
Check the machine for
damage, oil and coolant
leaks.
3
Check the hydraulic
system oil.
4
Check the battery
electrolyte level
(add
distilled water if needed).
Make sure the battery is
fully charged
.
5
Check the fuel level: LP
models – lift the engine
cover and replace the
Propane tank
(secure the
tank with the strap).
Gas and Diesel models -
carefully add fuel through
the fill port.
6
Check the engine air filter
service indicator – engine
models
(squeeze the rubber
dust cup to release built-up
dust).
Check the tire pressure
(90
- 95 psi for all tires).
7
Familiarize yourself with
the operator’s interface.
Adjust seat accordingly.
Insert key and turn
ignition on to continue
inspection.
8
Inspect controls, parking
brake, headlights, horn
and hour meter. Install
appropriate main broom.
Fill dust guard system
with clean water
(optional
for machines with this feature)
9
Plan cleaning route. Re-
inspect the parking brake
then prepare for sweeping.
Propane
To Next Page
Need help?
General
