Nilfisk-Advance SW8000 How-To

Page: 2
SW8000 How To
Machine Operation
1
Adjust seat to desired
position.
Start the machine. Release
parking brake.
2
Engage foot pedal then
transport to designated
work area (drive safely) .
3
Push the Lower Hopper
Switch.
Move the main broom
level to the sweep
(middle) position.
4
Turn off the dust control
switch when sweeping
floor with puddles.
5
Push the Shaker Switch to
clean the dust control
filter.
6
Check your cleaning path
occasionally to make sure
machine is picking up
debris.
7
Put the main broom lever
in the Up/Off position.
Use shaker to remove
excess dirt. Drive to
dumping site to empty
hopper.
8
Hold the raise hopper
switch. Position machine
over trash receptacle
Set parking brake
Press open dump door
switch
9
Apply Hopper Safety
switch. Lower the hopper.
Inspect hopper door and
front edge seal. Use a
broom to remove litter if
needed. Release parking
brake. Push the hopper
safety handle forward then
lower hopper. Prepare
machine for storage and
daily maintenance.

Nilfisk-Advance SW8000 Specifications

General

Brand	Nilfisk-Advance
Model	SW8000
Category	Floor Machine
Language	English