Nilfisk-Advance SW8000 How-To

Page: 3
SW8000 How To
After Use & Daily Maintenance
1
Shake the Hopper Dust
Control Filter.
Empty the hopper.
2
Shut down engine:
Raise brooms, change
engine speed to idle
(Gasoline/Diesel models), turn
service valve off (LPG), run
engine until all LOP is
dispelled from the line.
Apply parking brake
3
Check engine coolant,
engine oil, hydraulic oil
level, parking brake and
clean main and side brooms.
(gas, LPG and diesel models)
Occasional Maintenance
1
• Rotate Main Broom
• Clean the DustGuard
Spray Nozzles
2
• Inspect/adjust booms
• Clean Strainer
• Check/Clean Hopper
Dust Control Filter
using Method “A”
• Inspect broom
housing skirts
• Inspect hopper seals
• Clean radiator and oil
cooler
3
• Perform engine
maintenance
• Inspect and grease
steering spindle
• Check/Clean Hopper
Dust Control Filter
using Method “B”
4
• Check/Clean Hopper
Dust Control Filter
using Method “C”
5
• Change the hydraulic
oil filter
• Change the reservoir
hydraulic oil
• Flush the radiator
• Engine fuel filter(s)
6
Always refer to your
Mechanical Repair
Service Manual for
detailed maintenance
information.
After
15 Hours
Every 30 Hours
Every
150
Hours
Every 300 Hours
Every
100
0 Hours

Nilfisk-Advance SW8000 Specifications

General

Brand	Nilfisk-Advance
Model	SW8000
Category	Floor Machine
Language	English