5
EN
3 Before you start using your
pressure washer
3.1 Mounting of trolley
handle (models with
trolley handle)
1. Remove the label on top of
machine.
2. Push down the trolley handle
(12) into the machine. Secure
the handle by tightening the
2 screws.
3. Mount the hose hook (14)
on the handle (3 screws).
Note: the hose hook can be
mounted on the front as well
as on the back. Front position
is to be used if the product is
used together with a special
wall hook for wall storage.
3.2 Mounting of hose reel
handle (models with
hose reel)
1. Click the hose reel handle
on to the trolley handle (no
screws).
3.3 Mounting of quick
coupling
1. Screw the quick coupling
(16)tight on to the water inlet
(2).
Note: The inlet fi lter must al-
ways be fi tted in the water inlet
pipe to fi lter out sand, lime stone
and other impurities as these
will damage the pump valves.
Caution: Failure
to fi t the fi lter will
invalidate the
guarantee.
To Next Page
Loading...
Need help?
General
