WARNING
Always wear a helmet and other protective gear to minimize any possible injury in the learning
process. To reduce the risk of injury, adult supervision is required.
WARNING
Please check to make sure the kickscooter is powered o before assembly.
Note:
The screw should be placed behind.
Note:
For your safety, the hub motor will
not start if the speed is less than
1.2 mph (2 km/h).
In the power-on state, when the
kickscooter is still, you can step on
the rear fender twice to switch the
speed mode.
Please scan the QR code to learn how to activate the vehicle before riding, otherwise the vehicle
speed will be limited to 3.1 mph (5km/h).
1
4–8 years
≤88 lbs (40kg)
3'5''–4'7'' (105–140 cm)
Activation
Switch Speed Mode
3. Assembly and Activation
Insert the stem to the bottom and adjust
the handlebar direction to be perpendicular
to the front wheel.
1
Start up: Place a single foot on the footboard to start the kickscooter, then you will hear one
beep as the prompt.
2
Cruise: Hold the handlebar firmly with both hands and kick to start up. During the cruising,
place both feet on the footboard and keep your balance.
4. Learn to Ride
2
Tighten the two screws on the clamp to
make sure it is securely installed.
* When the indicator light turns red, please charge immediately.
NOTE:
The logo at the
wheel faces
forward.
07 08
To Next Page
Loading...
Need help?
General
