Ninja 3000 Series User Manual

www.Ninjapaintball.com
3
1.0 OPERATION with a HIGH PRESSURE COMPRESSED AIR BOTTLE
THIS FILL ADAPTER WILL VENT GASES STORED UNDER HIGH
PRESSURE MAKE CERTAIN THE VALVE VENT KNOB (part #5) IS
CLOSED (turned fully clockwise) BEFORE CONNECTING TO A HIGH
PRESSURE COMPRESSED AIR BOTTLE!
1.1 Close the vent station (part #4) by turning the vent knob (part #5) fully in a clockwise direction, do
not over tighten.
1.2 Turn the knob on the UFA (part #2) counter clockwise until it stops. Screw the UFA onto the High
Pressure Air bottle regulator making certain all components are clean and dry. Tighten securely by
hand ONLY. Do NOT use tools to tighten.
1.3 Ensure the air rifle you are filling has a 1/8 male Industrial Interchange quick disconnect, see
figure 1.4a. Pull the sleeve/collar back on the quick disconnect #6 and Connect the fill station
female quick disconnect socket (part #6) to the fill nipple on your PCP air gun. THE SLEEVE
/COLLAR MUST SNAP FORWARD AND BE SECURE! Do not force it on and if it does not fit
properly do not fill. See figure 1.4c.
1.4 MAKE SURE CONNECTION IS SECURE.

Ninja 3000 Series Specifications

General

Brand	Ninja
Model	3000 Series
Category	Paintball equipment
Language	English