Questions? 1-877-646-5288For how-to videos and more, visit ninjakitchen.com2 3
WHAT’S IN THE BOX
ADAPTER STORAGE BIN
USING THE NINJA POD ADAPTER AND PERMANENT FILTER
NINJA PODS & GROUNDS
COFFEE MAKER
ADAPTER STORAGE BIN
ADJUSTABLE CUP TRAY
56 OZ. REMOVABLE
WATER RESERVOIR
BREW BASKET
Comes fully installed in the brewer.
It must always be inserted when
brewing pods or grounds.
PERMANENT FILTER
Located in the adapter storage on
the right side of the unit. Permanent
Filter must always be inserted in the
brew basket when brewing grounds.
NINJA SMART SCOOP™
Use this to measure coee grounds.
The Ninja Single-Serve Pods & Grounds Coee Maker comes with the unique Ninja Pod Adapter already
installed and a Permanent Filter in the Adapter Storage Bin located on the right side of the coee maker.
Always ensure the Ninja Pod Adapter or Permanent Filter is installed in the brew basket.
The adapter storage is located on the right side of the unit and can be used for both the Permanent Filter
and Ninja Pod Adapter.
INSTALLING THE NINJA
POD ADAPTER
Place the Ninja Pod Adapter
in the brew basket, ensure
the handle is aligned with
the brew basket handle, and
press down on the Ninja Pod
Adapter firmly until it clicks
into place.
INSTALLING THE
PERMANENT FILTER
Place the Permanent
Filter in the brew basket
and ensure the handle
is aligned with the brew
basket handle.
OR
NINJA POD ADAPTER
Comes fully installed in the coee
maker. Ninja Pod Adapter must
always be inserted in the brew
basket when brewing pods.
If you live in a high-altitude area
be sure to run a calibration brew.
Refer to the Owner's Guide for
complete instructions.
BEFORE
YOUR
FIRST
BREW
TO PRIME YOUR COFFEE MAKER:
1 Clean all accessories before your first
brew.
2 Plug in the power cord and the coee
maker will turn on automatically.
3 Lift the water reservoir o its base.
Remove the reservoir lid. Fill the
reservoir up to at least the 24 oz. line
with fresh water and place it back on
the base.
4 Open the coee maker lid, remove
the Ninja Pod Adapter and insert the
Permanent Filter. Do not add coee;
close the lid.
5 Place a 24 oz. cup under the nozzle
and prime the system by running a
24 oz. Classic brew with water only.
6 Once the brew is complete, discard
the water; coee maker is now primed
for use.
NOTE: If using the brewer in a high-
altitude area, running a calibration
brew is required. Not running a
high-altitude calibration brew in
a high-altitude area will result in
excessive steaming during brewing.
Refer to page 5 of the Owner’s Guide
for instructions on running a high-
altitude calibration brew.
IMPORTANT: Ensure you prime your
coee maker before your first brew.
To Next Page
Loading...
