TIP: If the Stacked Blade Assembly is
not fully seated, you will not be able
to install and lock the lid into position.
NOTE: DO NOT add ingredients before
completing installation of the Stacked
Blade Assembly.
NOTE: The pitcher can be installed in
two dierent positions. The handle can
be positioned on the front-right corner
of the motor base or the front-left
corner of the motor base.
ASSEMBLING & USING YOUR
TOTAL CRUSHING® PITCHER
1 Plug in motor base and place on a
clean, dry, level surface such as a
countertop or table.
2 Lower the pitcher onto the motor
base, positioning it in a diamond
position, with the LOCK symbols
visible on the motor base.
3 To lock the pitcher in place,
rotate it to the left until you
hear a click.
4 Exercising care, grasp the Stacked
Blade Assembly by the top of the
shaft and place it onto the drive
gear inside the pitcher.
NOTE: The Stacked Blade Assembly
will fit loosely onto the drive gear.
5 Add ingredients, making sure to not
exceed the Max Fill line marked on
the side of the pitcher.
6 Place the lid on the pitcher, aligning
the triangle symbol located on the
lid with the triangle symbol located
on the pitcher’s handle. Press down
on the handle until you hear a click.
NOTE: The triangle symbols MUST
be aligned for the lid to lock into
place and the unit to operate.
To Next Page
Loading...
Need help?
General