Nintendo Entertainment System CONTROL DECK - Page 25

REMEDY:
Make
sure
your television
set
is turned
on and
tine
power cord
is
plugged
in.
Make sure
the
power switch on
the control deck
is turned
on.
Make sure
that
the AC
adapter
is plugged into
a 110/120 volt
wall
outlet and
that
the
AC adapter
output
jack
is
plugged into the
Control
Deck.
Make sure
that the Controt
Deck and
the antenna
wire
are
connected to the RF
switch
properly
and that the
RF
switch is
connected
to
the
TV
(refer
to
"Connecting
the NES
Control
Deck
to
Your TV Set").
Make
sure the
game pak
is
inserted
into the
control
deck
correctly
(refer
to the
game
pak
insertion
section
in your
NES
Instruction
Malual).
Also, try
pressing
the reset
switch
on
your
Control
Deck
or try turning
the
power
switch
off
and
then
turning
it
on
again.
Make
sure that
the
Channel 3/Channel
4 switch
on the
Control Deck is set to Channel
3
and
that the
TV is
set to Channel
3.
Adjust
the
vertical
or
horizontal
hold
controls on
your
television
until picture
becomes
steady.
If
there
is interference
on Channel
3,
change
the Channel
3/Channel 4
switch
on your
Control
Deck
to
Channel
4 and
set your TV
to
Channel
4.
A
particularly
strong
television
station
may be broadcasting
on Channel
3
or
4 (or
on
cable TV) in
your
area and causing
interference.
Try disconnecting
the antenna
wire
from
the RF switch,
(You will have
to
reconnect
it again
for regular
television
viewing.)
21