Nirvana E60 - 9.3 SELECTION OF MODE (MODEL C95 ONLY); BACKWASH OPERATIONS; CHANGING THE DISPLAY FROM F° TO C°; RESETTING THE DISPLAY

19
9.3SELECTIONOFMODE(MODELC95ONLY)

TokeeptheunitintheHEATMODEONLY:Pressthe"SELECT"until"ACH"appearsandpressthearrowkeysuntil
"HEA"appears.Thereafteritremainsonlytochoosethedesiredtemperature.Thisfeatureallowsyoutocontrolthe
minimumleveldesired.Theunitwillheatthewateruntilthedesiredtemperatureisreached.

TokeeptheunitinCOOLINGMODEONLY:Pressthe"SELECT"until"ACH"appearsandpressthearrowkeysuntil
"COL"appears.Thereafteritremainsonlytochoosethedesiredtemperature.Thisfeatureallowsyoutocontrolthe
desiredmaximumdegree.Theunitwillcoolthewateruntilthedesiredtemperatureisreached.

ToputtheunitinAUTOMODE:Pressthebutton"SELECT"until"ACH"appearsandpressthearrowkeysuntil"AU"
appears.Thereafteritremainsonlytochoosethedesiredtemperature.Thisfunctionkeepswateratdesired
temperature.Inotherwords,itwillheatorcoolwateruntilthewatertemperaturereachesthedegreeselected.

BACKWASHOPERATIONS

1. Carryoutthebackwashprocedureasfollows:

2. TurnOFFthepowertothepump(withpowersupplyor(FIL=OFF,POL=OFFandSPAOFF)).
3. PreparethesystemforbackwashandpowerONthepump(withpowersupplyor(FIL=ON)).
4. ThecirculatingpumpwillgoONandthecontrollerwillnotcheckfor5minutesifwaterflowispresentatthe
flowswitch.

5. Youwillhave5minutesofuninterruptedwaterflowtodothebackwash.
6. Stopthecirculatingpump(usethepowersupplyorFIL=OFF).
Normally,whenthecirculatingpumpisrequiredforthisoperationandthereisnowaterflowdetectedatthecontrol,
thepumpwillautomaticallyturnOFF.Thisprocedurewillgivea5minuteperiodofuninterruptedwaterflowbefore
thecirculatingpumpturnsOFF.

CHANGINGTHEDISPLAYFROMF°TOC°

FactorydefaultsareinF°.

 PressandholddowntheSETkeyuntilthemessagePOLappears.
 PresstheSETkeyuntilF_Cisdisplayed.

 Pressthe↑keytoselect°Forpressthe↓keytoselect°C.

RESETTINGTHEDISPLAY

If a flashing PLE or CSE error message is displayed, hold down the SET key until the error message is no longer
displayed(approx.4seconds).Thecontrolwillberesettothefactorydefault.

Reprogramallthesettings.
DE‐ICINGOPERATION

Duringtheevaporatorcoilde‐icingcycle,FSwillbedisplayedtoindicatethattheunit isde‐icing.Duringthistime,the
fanisonandthecompressorisnotinoperation