PRECAUTIONS
CO-3
C
D
E
F
G
H
I
J
K
L
M
A
CO
Revision: October 2006 2006 Maxima
3. Attach liquid gasket tube to Tool.
Use Genuine RTV Silicone Sealant or equivalent. Refer to
GI-45, "
Recommended Chemical Products and Sealants" .
4. Apply liquid gasket without breaks to the specified location with
the specified dimensions.
● If there is a groove for the liquid gasket application, apply liq-
uid gasket to the groove.
● As for the bolt holes, normally apply liquid gasket inside the
holes. Occasionally, it should be applied outside the holes.
Make sure to read the text of service manual.
● Within five minutes of liquid gasket application, install the mat-
ing component.
● If liquid gasket protrudes, wipe it off immediately.
● Do not retighten nuts or bolts after the installation.
● After 30 minutes or more have passed from the installation, fill
engine oil and engine coolant.
CAUTION:
If there are specific instructions in this manual, observe them.
Tool number : WS39930000 ( — )
WBIA0567E
SEM159F
To Next Page
Loading...