EM-54
< REMOVAL AND INSTALLATION >
[VQ40DE]
FRONT TIMING CHAIN CASE
22. Remove front oil seal from front timing chain case using suitable
tool.
CAUTION:
Be careful not to damage front timing chain case.
23. Remove idler pulley, if necessary. Refer to EM-14, "Drive Belt Auto-Tensioner and Idler Pulley"
.
24. Use a scraper to remove all traces of old liquid gasket from front
and rear timing chain cases, oil pan (upper), and liquid gasket
mating surfaces.
CAUTION:
Be careful not to allow gasket fragments to enter oil pan.
• Remove old liquid gasket from bolt hole and thread.
25. Use a scraper to remove all traces of old liquid gasket from
water pump cover, chain tensioner cover (if necessary) and
intake valve timing control covers.
INSTALLATION
PBIC2909E
PBIC2910E
PBIC2084E
SEM926E
Revision: January 2013 2013 Xterra
To Next Page
Loading...