[ Edit: 2016/ 11/ 24 Model: E12-A ]
E12-A-120227-7836E316-5FAE-45D9-AF28-B95374DCA4D8
1. Apply the parking brake.
2. Move the shift lever to the “P” (Park) or “N”
(Neutral) position.
The starter is designed to operate only when
the shift lever is in the proper position.
The Intelligent Key must be carried when
operating the ignition switch.
3. Push the ignition switch to the “ON” position.
Depress the brake pedal and push the ignition
switch to start the engine.
To start the engine immediately, push and release
the ignition switch while depressing the brake
pedal or clutch pedal with the ignition switch in
any position.
4. Immediately release the ignition switch when the
engine starts. If the engine starts, but fails to run,
repeat the above procedures.
If the engine is very hard to start in extremely cold
or hot weather, depress the accelerator pedal and
hold it. Push the ignition switch for up to 15
seconds while holding. Release the accelerator
pedal when the engine starts.
CAUTION:
. As soon as the engine has started, release
the ignition switch immediately.
. Do not operate the starter for more than 15
seconds at a time. If the engine does not
start, push the ignition switch to the “OFF”
position and wait 10 seconds before crank-
ing the engine again. Otherwise, the starter
could be damaged.
. If it becomes necessary to start the engine
with a booster battery and jumper cables,
the instructions and cautions contained in
the “6. In case of emergency” section should
be carefully followed.
5. Allow the engine to idle for at least 30 seconds
after starting the engine to warm-up. Drive at
moderate speeds for a short distance first,
especially in cold weather.
CAUTION:
Do not leave the vehicle unattended while the
engine is warming up.
6. To stop the engine, move the shift lever to the “P”
(Park) position, apply the parking brake and push
the ignition switch to the “OFF” position.
E12-A-120227-823B81B0-9920-4FBE-A8C7-A21047D18FCF
DRIVING WITH CONTINUOUSLY VARI-
ABLE TRANSMISSION (CVT)
E12-A-120227-1000FFA4-47B6-473C-BD6E-147BEB14BE4F
The Continuously Variable Transmission (CVT) in your
vehicle is electronically controlled to produce maximum
power and smooth operation.
The recommended operating procedures for this
transmission are shown on the following pages. Follow
these procedures for maximum vehicle performance
and driving enjoyment.
WARNING:
Do not downshift abruptly on slippery roads.
This may cause a loss of control.
CAUTION:
. The cold engine idle speed is high, so use
caution when shifting the transmission into
a forward or reverse position before the
engine has warmed up.
. Avoid revving up the engine while the
vehicle is stopped. This could cause unex-
pected vehicle movement.
. Never shift to either the “P” (Park) or “R”
(Reverse) position while the vehicle is mov-
ing forward and "P" (Park) or "D" (Drive)
position while the vehicle is reversing. This
could cause an accident or damage the
transmission.
. Except in an emergency, do not shift to the
“N” (Neutral) position while driving. Coast-
ing with the transmission in the “N” (Neutral)
position may cause serious damage to the
transmission.
Starting and driving 5-7
STARTING ENGINE DRIVING VEHICLE
Condition:
To Next Page
Loading...