Nissan NOTE - Page 152

2. Select the [Pair Device] key.
The pairing procedure depends on the
connected device:
•
Mobile phone:
The message [Ready to Pair Pin:1234] will
be displayed.
•
Audio device without PIN code:
The Bluetooth connection will be automati-
cally connected without any further input.
•
Audio device with PIN code:
A new screen will appear. Assign the 4 digit
PIN code by turning the <TUNE/MENU> dial
to each code and press the <ENTER> button
to confirm. Then select [Validate] and press
<ENTER>. The Bluetooth connection will be
made.
The 4–digit PIN code is provided with the
audio device, see the owner’s manual of the
audio device.
3. On Bluetooth® audio/mobile phone devices.
1) Switch on the Bluetooth® connection, if not
already switched on.
2) Switch on the search mode for Bluetooth®
devices. If the search mode finds a device it
will be shown on the device display.
3) When a device is found use the <TUNE/
MENU> dial to scroll to, and press <ENTER>
to select [My Car].
4) Enter the number code shown on the relevant
device with the device’s own keypad, and
press the confirmation key on the device it-
self. Refer to the relevant Bluetooth® device
owner’s manual for further details.
When successfully paired a notification message
will be displayed, then the audio system display
will return to the current audio source display.
During connection the following status icons will
be displayed (top left of the display): Signal
strength (
), Battery status* ( ) and
Bluetooth “ON” (
).
*: If the low battery message comes on, the
Bluetooth® device must be recharged soon.
The pairing procedure and operation may vary ac-
cording to device type and compatibility. See the
Bluetooth® owner’s manual for further details.
NOTE
•
For device details, see your audio/mobile
phone Owner’s Manual.
•
For assistance with the Bluetooth® audio/
mobile phone integration, please visit your lo-
cal NISSAN dealer or qualified workshop.
[Select Device]:
The paired device list shows which Bluetooth® au-
dio or mobile phone devices have been paired or
registered with the Bluetooth® audio system. If the
list contains devices then select the appropriate de-
vice to connect to the Bluetooth® audio system.
The following symbols (where fitted) indicate the
capability of the registered device:
•
: Mobile phone integration
•
: Audio streaming (A2DP – Advanced Audio
Distribution Profile)
[Delete Device]:
A registered device can be removed from the
Bluetooth audio system. Select a registered device
then press <ENTER> to confirm to deletion.
[On/Off]:
If Bluetooth® has been switched off a notification
message [On/Off] appears when you select
[Bluetooth] from the setup menu screen, or press
<
>. To switch the Bluetooth® signal on, press
<ENTER> and a follow up screen will appear. Then
select [On] and press <ENTER> to display the
Bluetooth® settings menu screen.
4-36 Heater and air conditioner, and audio system