Activation
At ignition ON. Once the vehicle starts moving the
tyre pressure is monitored.
TPMS sensor ID and position
recognition
When the tyre pressure sensors have been changed
the TPMS system recognises new or different tyre
pressure sensors and will synchronise automatically
while driving.
•
Registration of a new TPMS sensor.
After addition of the TPMS sensor to the vehicle,
drive the vehicle for several minutes between 25
(16 MPH) and 100 km/h (64 MPH). The TPMS
sensor ID and position will automatically be de-
tected and the new TPMS sensor will be regis-
tered.
•
After tyre rotation
After relocating the TPMS sensors on the ve-
hicle, drive the vehicle for several minutes be-
tween 25 (16 MPH) and 100 km/h (64 MPH).
The TPMS sensor ID and positions will automati-
cally be detected and the new TPMS sensor
locations will be registered.
NOTE
The TPMS might not calibrate if one or more of
the following conditions apply:
•
Bad road conditions
•
The TPMS unit doesn’t receive correct data
from tyre pressure sensors
•
Driving below 25 km/h (16 MPH)
•
Driving above 100 km/h (64 MPH)
•
High acceleration
•
High deceleration
•
In stop and go traffic or traffic waves
Starting and driving 5-7
To Next Page
Loading...