Trip computer jB and clock appear on the centre
display inside the speedometer.
When the ignition switch is placed in the ON posi-
tion, the trip computer can be selected by pushing
the trip computer mode switch.
Each time the trip computer mode switch is pushed,
the display
jA will change as follows:
Current fuel consumption → Average fuel consump-
tion → Range → Average speed → Elapsed time →
TPMS settings
Current fuel consumption (km/l)
m
The current fuel consump-
tion mode shows the cur-
rent fuel consumption.
Average fuel consumption (km/l)
m
The average fuel
consumption mode shows
the average fuel consump-
tion since the last reset.
Resetting is done by pushing the trip computer mode
switch
jA for longer than 1 second.
The display is updated every 30 seconds. At about
the first 500 m (1/3 miles) after a reset, the display
shows “— — —”.
Range (km)
m
The range mode provides
you with an estimation of
the distance that can be
driven before refuelling.
The range is constantly being calculated, based on
the amount of fuel in the fuel tank and the actual fuel
consumption.
The display is updated every 30 seconds.
The range mode includes a low range warning fea-
ture: when the fuel level is low, the range mode is
automatically selected and the digits blink in order
to draw the driver’s attention. Push the trip com-
puter mode switch
jA to return to the mode that
was selected before the warning occurred.
When the fuel level drops even lower, the range dis-
play will change to “————”.
•
If the amount of fuel added is small, the dis-
play just before the ignition switch is turned
off may continue to be displayed.
•
When driving uphill or rounding curves, the
fuel in the tank shifts, which may momentarily
change the display.
Average speed
m
The average speed mode
shows the average vehicle
speed since the last reset.
Resetting is done by pushing the trip computer mode
switch
jA for longer than 1 second.
Elapsed time
m
The elapsed time mode
shows the time since the
last reset.
The displayed time can be reset by pushing the trip
computer mode switch
jA for longer than 1 second.
Tyre Pressure Monitoring System
(TPMS) setting
General information, please see “Tyre Pressure
Monitoring System (TPMS)” in the “5. Starting and
driving” section for more details.
Instruments and controls 2-3
To Next Page
Loading...