The wrench symbol and the remaining distance to
oil change information is displayed as a reminder to
perform the oil change or a maintenance service on
time.
To set the distance to oil change (maintenance) pro-
ceed as follows:
1. Turn the ignition switch to the ON position, and
within 3 seconds, while the distance to oil change
and the wrench symbol (
) are still displayed,
push the trip odometer switch at least for 3 sec-
onds and the distance will start flashing.
2. Each time the trip odometer switch is pushed,
the distance will be extended. The distance is
extended by 1,000 km (500 miles) each time the
switch is pushed. The distance can be set within
a range of 0 to 30,000 km (18,000 miles).
3. Do not touch any switches for at least 5 sec-
onds; the new distance to oil change will then be
set in the trip computer.
If the distance to oil change is set to 0 (zero), the
distance and the wrench symbol will not be dis-
played when the ignition switch is placed in the ON
position.
MAINTENANCE INFORMATION diesel
models
j
1
Normal operation
j2
Remaining distance to next oil change
j3
Oil change is overdue
j4
Error message
NOTE
The maintenance interval will reduce faster with
certain types of driving, especially at low speeds
in urban conditions.
CAUTION
•
The engine oil must be changed before re-
maining distance to next oil change falls to 0
km (miles).
•
Failure to change engine oil on time risks
causing damage to the engine.
•
Continued driving after remaining distance to
next oil change reaches 0 km (miles) may re-
sult in reduced engine performance. The en-
gine malfunction indicator light (orange) will
illuminate.
•
The DPF (where fitted) may also become satu-
rated because regeneration is restricted once
the distance equals 0 km (miles)
•
When “Oil Lo” is displayed, fill the engine with
the correct oil as soon as possible. For de-
tails, see “Engine oil” in the “8. Maintenance
and do-it-yourself” section.
•
The oil level check is not designed to be the
only indicator of a low oil level. Use the dip-
stick to check the oil level. For details, see
“Engine oil” in the “8. Maintenance and
do-it-yourself” section.
•
NISSAN recommends checking the oil level
every 5,000 km (3,000 miles).
Always visit a NISSAN dealer or qualified work-
shop to perform the oil maintenance and dis-
tance to oil change reset. The distance to oil
change must be reset after the oil has been
changed, For details, see “Reset oil change
interval” later in this section.
When the ignition switch is placed in the ON posi-
tion, the display in the speedometer will change in
the following order:
Remaining distance to oil change (with a wrench
symbol
) j1 → Oil level status (“Oil Good” or “Oil
Lo”) → odometer/ twin trip odometer
NIC1995
2-6 Instruments and controls
To Next Page
Loading...